This announcement contains inside
information
2 April 2024
88 Energy
Limited
HICKORY-1 UPPER SFS ZONE
FLOWS LIGHT OIL
Highlights
· Flow
testing of the Upper SFS (USFS) reservoir confirms light oil
discovery at Hickory-1.
· USFS flow
rates achieved from low volume frac over small 20ft vertical
interval are in line with expectations and results observed from
other reservoirs on adjacent acreage.
· USFS test
produced at a peak gauge flow rate of over 70 barrels of oil per
day (bopd) of light oil.
Multiple oil samples recovered, measuring ~40-degree API oil
gravity.
· Quality
and deliverability of the USFS reservoir now confirmed via oil
production to surface under natural flow, with flow back fluids
including unquantified volume of marketable natural gas liquids
(NGLs) and associated gas,
consistent with tests on adjacent acreage.
· 88 Energy
will now seek an Independent Contingent Resource declaration for
both the Upper SFS and Lower SFS reservoirs based on the flow of
hydrocarbons to surface.
· Flow
testing operations will transition to testing the shallower SMD-B
reservoir over the next few days, in-line with the multi-reservoir,
staged flow test approach adopted for Hickory-1.
88 Energy Limited (ASX:88E, AIM:88E,
OTC:EEENF) (88 Energy or the Company) is pleased to announce successful flow testing of the Upper
SFS reservoir in the Company's Hickory-1 discovery well, located in
Project Phoenix on the North Slope of Alaska (88 Energy ~75% WI
owner).
Managing Director, Ashley Gilbert,
commented:
"Outcomes from this test represent a significant milestone for
88 Energy and its shareholders, with the first successful flow of
oil to surface achieved at the Company's Alaska
projects.
The completion of flow testing in this zone and recovery to
surface of light oil, in addition to NGLs and associated gas,
confirms our understanding of the substantial potential of these
reservoirs. Significantly, these flow rates were achieved from only
a 20ft perforated section in a vertical well with a low volume
stimulation over a short period. As previously highlighted,
production rates in long horizontal production wells are typically
multiples of 6 to 12 times higher than tested in vertical wells, as
evidenced in many Lower 48 analogues.
Importantly, the Upper SFS zone had not previously been
intersected or tested at either Project Phoenix or on adjacent
acreage. It is particularly exciting for us to produce oil to
surface and demonstrate the producibility of this additionally
discovered reservoir. Future plans for the assessment of the
commerciality of Project Phoenix will be communicated post analysis
of the Hickory-1 program.
We
will now proceed to undertake flow testing of the shallower SMD-B
reservoir over the coming weeks. This is a zone which has
previously been successfully tested on adjacent acreage to the
north.
We
look forward to continuing to update shareholders on the progress
of our Hickory-1 flow testing operations."
Upper SFS flow test results
A 20ft perforated interval in the
Upper SFS reservoir was stimulated via a single fracture stage of
241,611 lbs proppant volume. The well was cleaned-up and flowed for
111 hours in total, of which 88 hours was under natural flow back
and 23.5 hours utilising nitrogen lift.
The USFS test produced at a peak
flow rate of over ~70 bopd. Oil cuts increased throughout the flow
back period as the well cleaned up, reaching a maximum of 15% oil
cut at the end of the flow test program. Oil rates and cut would
have likely increased further should the test period have
continued. The well produced at an average oil flow rate of
approximately 42 bopd during the natural flow back period, with
instantaneous rates ranging from approximately 10 - 77 bopd with
average rates increasing through the test period.
Importantly, the USFS zone flowed oil to surface under
natural flow, with flow back from other reservoirs in adjacent
offset wells only producing under nitrogen lift. A total of
3,960bbls of fluid was injected into the reservoir and 2,882bbls of
water was recovered during the flow back period, most of which
being injection fluid. Total flow rates (inclusive of recovery of
frac fluid) averaged ~600 bbl/d over the duration of the flow
back.
Multiple oil samples were recovered
with measured oil gravities of between 39.9 to 41.4 API
(representing a light crude oil).
Additionally, some NGLs were
produced but not measured, as was anticipated in the planning
phase. The presence of NGLs was demonstrated by samples from the
flare line and by visible black smoke in the flare. Historically,
NGL prices on the North Slope of Alaska have been similar or
slightly below light oil prices and are therefore considered highly
valuable. Further work is required to quantify the exact volume of
NGLs, which 88 Energy intends to include as part of a maiden
certified Contingent Resource assessment at Project Phoenix for the
SFS reservoirs.
Figure 1: (left) Two sample bottles of 41.4-degree API oil
sampled from the oil leg in the separator. (middle)104-degree
Fahrenheit fluid sample from Hickory-1 USFS flow test, which is
temperature corrected to 41.4-degree API at 60F (right) Sample of
NGLs taken from the gas flare line.
Figure 2
Successful flow test undertaken on the Upper SFS reservoir in
Project Phoenix.
SMD-B flow testing operations
Preparation for the next state of
the Hickory-1 flow testing schedule in underway and will focus on
the proven SMD-B reservoir. As with the USFS test, this zone will
be independently isolated, stimulated and flowed to
surface.
Testing operations are scheduled to
complete in April 2024, with the on ground Alaskan team working
hard to progress to this next stage as quickly as possible. Weather
condition have been particularly challenging with low temperatures
and high winds experienced during operations to date.
Further updates on the Hickory-1
flow test operations will be provided in due course.
Additional information related to
Hickory-1:
Hickory-1 is located in State lands
on the North Slope of Alaska, adjacent to the Dalton Highway and
Trans Alaska Pipeline, within Alaskan Oil and Gas lease ADL 392314.
88 Energy holds a ~75% working interest in the well and is
Operator. The well spudded on 9 March 2023 and was drilled to a
Total Depth of 10,650 feet. Multiple prospective pay zones in
sandstone reservoir between depths 7,700 and 10,500 were
identified.
88 Energy reported a maiden,
independently certified Contingent Resource estimate of 136 MMbbl
of hydrocarbon liquids (gross best estimate (2C)) and 628 BCF of
gas, for the Basin Floor Fan (BFF) reservoir in Project Phoenix on
6 November 2023.
Figure 3: Flaring of gas and NGLs.
This
announcement has been authorised by the Board.
Media and Investor Relations:
88
Energy Ltd
Ashley Gilbert, Managing
Director
Tel: +61 8 9485 0990
Email:investor-relations@88energy.com
|
|
|
|
Fivemark Partners, Investor and
Media Relations
|
|
Michael Vaughan
|
Tel: +61 422 602 720
|
|
|
EurozHartleys Ltd
|
|
Dale Bryan
|
Tel: + 61 8 9268 2829
|
|
|
Cavendish Capital Markets Limited
|
Tel: +44 (0)207 220 0500
|
Derrick Lee
|
Tel: +44 (0)131 220 6939
|
Pearl Kellie
|
Tel: +44 (0)131 220 9775
|
|
|
Pursuant to the requirements of the
ASX Listing Rules Chapter 5 and the AIM Rules for Companies, the
technical information and resource reporting contained in this
announcement was prepared by, or under the supervision of, Dr
Stephen Staley, who is a Non-Executive Director of the Company. Dr
Staley has more than 40 years' experience in the petroleum
industry, is a Fellow of the Geological Society of London, and a
qualified Geologist/Geophysicist who has sufficient experience that
is relevant to the style and nature of the oil prospects under
consideration and to the activities discussed in this document. Dr
Staley has reviewed the information and supporting documentation
referred to in this announcement and considers the resource and
reserve estimates to be fairly represented and consents to its
release in the form and context in which it appears. His academic
qualifications and industry memberships appear on the Company's
website and both comply with the criteria for "Competence" under
clause 3.1 of the Valmin Code 2015. Terminology and standards
adopted by the Society of Petroleum Engineers "Petroleum Resources
Management System" have been applied in producing this
document.
Appendix A
Reporting of Material Exploration and Drilling Results
Pursuant to ASX Listing Rules, Chapter 5
ASX
Listing Rule
|
Requirement
|
Hickory-1 Well Test Reporting
|
5.30
|
(a)
|
The name and type of well
|
Hickory-1, vertical exploration
well
|
|
(b)
|
The location of the well and the
details of the permit or lease in which the well is
located
|
Hickory-1 is located in State lands
on the North Slope of Alaska, adjacent to the Dalton Highway and
Trans Alaska Pipeline, within Alaskan Oil and Gas lease ADL
392314
|
|
(c)
|
The Company's working interest in
the well
|
~75%
|
|
(d)
|
Gross pay thickness and net pay
thickness
|
N/A
|
|
(e)
|
Geological rock type of the
formation drilled
|
Sandstone
|
|
(f)
|
Depth of the zones tested
|
Upper SFS perforation interval:
9,005' - 9,025' MDRT
|
|
(g)
|
Types of tests undertaken and the
duration of the tests
|
Fracture stimulate and flow test the USFS
formation, utilising a combination of natural and nitrogen
lift. The well flowed naturally for a
period of approximately 88 hours and flowed under nitrogen lift for
an approximately 23 hours period.
|
|
(h)
|
The hydrocarbon phases recovered in
the tests
|
Oil and gas were recovered and
measured. A proportion of NGLs were possibly captured in the oil
stream, however, not separately measured. Gas samples taken will be
analysed post the flow test operations to determine proportion of
NGLs.
|
|
(i)
|
Any other recovery, such as
formation water and water, associated with the tests and their
respective proportions
|
2,882 bbls of water was recovered
during flow back, consisting of frac fluids injected into the
reservoir (approximately 3,960 bbls of fluid was injected during
frack operations). Further analysis of fluids will be conducted
post the flow test to determine extent of reservoir
fluids.
|
|
(j)
|
The choke size and flow rates and,
if measured, the volumes of the hydrocarbon phases
measured
|
Various choke sizes used during flow
back operations from 8/64ths to 42/64ths of an inch. Total flow
rates (inclusive of recovery of frac fluid) averaged ~600bbl/d over
the duration of the flow back. Oil cut following establishment of
production ranged from 3% to 15% at the end of the test period. A
total volume during the flow back period following establishment of
oil cut of 24.8 stk bbls of oil recovered following establishment
of oil rates. A total of 1.45mmscf of gas and NGL's were recovered
from the Upper SFS test, though proportions of marketable NGLs will
be determined during post well analysis.
|
|
(k)
|
If flow rates were tested,
information about the pressures associated with the flow and the
duration of the test
|
Well head pressures over the
duration of the natural flow back period ranged from 2,000 to
420psig. Whilst nitrogen lift occurred pressures ranged from 250 to
1,000psig.
|
|
(l)
|
The number of fracture stimulation
stages and the size and nature of fracture stimulation
applied
|
The Upper SFS zone was stimulated in
a single stage and utilised a cross-linked polymer gel. The volume
of sand proppant pumped was 241,660 lbs for the Upper
SFS.
|
|
(m)
|
Any material volumes of
non-hydrocarbon gases, such as carbon dioxide, nitrogen, hydrogen
sulphide and sulphur
|
The Upper SFS test showed no
measurable CO2 or H2S. No other impurities were detected on
site.
|
|
(n)
|
Any other information that is
material to understanding the reported results
|
The Company will conduct post flow
test analysis to determine the quantity of marketable NGLs that
were produced. Pressurised gas and oil samples have been taken. The
company anticipates NGLs produced to be at a similar rate to those
observed during flow tests on adjacent acreage given the
consistency of results observed between the USFS test and tests
conducted on adjacent wells.
|